KnowledgeBase Archive

An Archive of Early Microsoft KnowledgeBase Articles

View on GitHub

Q114653: Err Msg: Failure: PROTOCOL.INI Does Not Have a DRIVERNAME=

Article: Q114653
Product(s): Microsoft Windows 3.x Retail Product
Version(s): WINDOWS:3.11
Operating System(s): 
Keyword(s): 
Last Modified: 24-SEP-1999

-------------------------------------------------------------------------------
The information in this article applies to:

- Microsoft Windows for Workgroups version 3.11 
-------------------------------------------------------------------------------

SYMPTOMS
========

When the NET START command is executed, you receive one or more of the following
error messages

  Failure: PROTOCOL.INI does not have a DRIVERNAME=xxx.

  Failure: Protocol Manager did not accept xxx.

  Failure: NDIS environment invalid. Driver not loaded.

  Error loading device driver xxx.

  Error 7306: The driver failed to initialize.

  xxx was not loaded.

  Error 7321: Network card drivers failed to load.

where "xxx" is your network card driver name (for example, EXP16 or EXP16.DOS).

CAUSE
=====

If you install a second network interface card (NIC) of the same brand and model
as the original and then load an NDIS 2 (real-mode) driver and protocol for this
card, you encounter problems if the initial adapter is using an NDIS 3
(protected-mode) driver and protocol.

Because an NDIS 2 driver must run in real mode, it is initialized before Windows
for Workgroups 3.11 is loaded. The adapter binding with the NDIS 2 driver
becomes the first physical adapter. To complete the binding process, the NDIS 2
driver looks in the PROTOCOL.INI file for a DriverName=FirstDriverInstance$
setting. Because an NDIS 3 driver was installed first, no such setting exists
since NDIS 3 drivers do not require this setting.

RESOLUTION
==========

To avoid the above error messages, perform the following steps:

1. Choose the Network Setup icon in the Network group.

2. Choose the Drivers button.

3. Remove both network card drivers.

4. Choose Close, then choose OK. (Allow Windows to reboot the computer when you
  are prompted to do so.)

5. Restart Windows.

6. Choose the Network Setup icon in the Network group.

7. Choose the Drivers button.

8. Add the network card driver for your network card.

9. Set up this card with the NDIS 2 driver and protocol.

10. Add the second instance of the network card driver for your network card.

11. Set up this card with the NDIS 3 driver and protocol.

12. Choose Close, then choose OK. (Allow Windows to reboot the computer when you
  are prompted to do so.)

Additional query words: 3.11 errors ndis2 ndis3

======================================================================
Keywords          :  
Technology        : kbAudDeveloper kbWFWSearch kbWFW311
Version           : WINDOWS:3.11

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.