KnowledgeBase Archive

An Archive of Early Microsoft KnowledgeBase Articles

View on GitHub

Q94604: Incorrect SMARTDrive BufferSize Setting Hangs System

Article: Q94604
Product(s): Microsoft Windows 95.x Retail Product
Version(s): WINDOWS:3.1,3.11
Operating System(s): 
Keyword(s): 
Last Modified: 25-SEP-1999

-------------------------------------------------------------------------------
The information in this article applies to:

- Microsoft Windows versions 3.1, 3.11 
- Microsoft Windows for Workgroups versions 3.1, 3.11 
-------------------------------------------------------------------------------

SUMMARY
=======

SMARTDrive version 4.0, the disk-caching utility supplied with Windows, has a
switch, /b:BufferSize, that enables you to change the default size of
SMARTDrive's buffer. If this switch contains an invalid entry, the result could
hang the system during startup, requiring a boot (system) disk to start the
computer.

MORE INFORMATION
================

SMARTDrive's buffer is separate from the cache. Data is initially transferred to
the buffer's memory, then written to the cache in portions, as determined by the
/e:ElementSize switch. The default element size is 8192 bytes.

The BufferSize setting is measured in bytes and has a default value of 16K. Page
540 of the "Microsoft Windows User's Guide" states that the valid values for
BufferSize can be any multiple of the ElementSize setting. The guide provides no
upper limit. However, there is an upper limit on the BufferSize setting based on
how much memory is available in the upper memory area (UMA) or in conventional
memory.

The valid entries for ElementSize and BufferSize are as follows:

  If This Value
  Is Used for /e        Use This Value for /b
  ------------------------------------------------------------------

  /e:1024               Multiples of /e up to and including /b:16384
  /e:2048               Multiples of /e up to and including /b:32768
  /e:4096               Multiples of /e up to and including /b:57344
  /e:8192               Multiples of /e up to and including /b:57344

If you attempt to use any other values, you may experience one of the following
problems:

- The system stops responding (hangs).

- The error message "Sector not found reading drive x" (where "x" is the drive
  being accessed after SMARTDrive is loaded) appears.

- The size of SMARTDrive's buffer will not match the BufferSize setting.

For additional information about SMARTDrive, refer to pages 539-541 in the
"Microsoft Windows User's Guide."

Additional query words: 3.10 3.1 smartdrv smartdrv.exe buffer size crash lock lockup DocErr smart drive

======================================================================
Keywords          :  
Technology        : kbAudDeveloper kbWin3xSearch kbWFWSearch kbZNotKeyword3 kbWin310 kbWin311 kbWFW310 kbWFW311
Version           : WINDOWS:3.1,3.11

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.