Q34009: Jumper Settings for Bus Mouse Used in an XT 286

Article: Q34009
Product(s): See article
Version(s): 1.x 2.x 3.x 4.x 5.x 6.x 1.00
Operating System(s): MS-DOS
Keyword(s): ENDUSER | | mspl13_basic
Last Modified: 23-AUG-1988

For the purpose of setting the jumpers on the bus mouse card, the
IBM XT 286 is equivalent to an IBM AT. The hard disk in the IBM XT 286
uses IRQ 2. The typical settings are as follows:

   Jumper    Setting
     J2      normal
     J3      primary
     J4      IRQ 5

   As always, be sure that IRQ 5 is not being used for other hardware
devices, such as a Bernoulli box, network card, or tape backup.

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1986-2002.